The curve of the original pieces didn’t quite match the curve of the center dock so we had to cut small slots into the material to make it curve a little bit more so that it would fit properly. This trim will cover everything up to make it look better and, more importantly, make it safer. The edges of the honeycomb not only look rough and unfinished but are also pretty sharp and jagged.
There are tons of ways to customize the look and feel of the Dock.
#CDOCK DESKTOP AND DOCK FLASHING FULL#
The purpose of the flashing is to work as a trim to cover up the rough edges of the honeycomb material that we use to make the walking surfaces for the dock and walkways to the outer spars. cDock gives you full control over the Dock. We had to measure and then drill holes in the flashing so that it would slide over the posts for the railing. We made 8 of these fiberglass pieces that will go around the entire circumference of the dock. If that doesn't work, try restarting your computer. Paste the cDock.bundle file into this folder.
We are getting the flashing installed on the center dock. Go to your hard-drive folder (usually Macintosh HD unless you've renamed it). If you find one or more of the DisplayLink connected screens are going blank for about one second, then coming back on, and the windows on the DisplayLink display have not moved to another display, it is probably caused by the monitor losing sync with the video output from the DisplayLink video output.
0 kommentar(er)
